I have seen some floors made with microlam header material riped down to 3/4" strips laied down to show the edge grain. It looks gorgeous. I was wondering if anyone has done this or seen this elseware. I have a few questions about it.
Do I need to route a toung and grove in it. How should I nail it to the sub floor. Does it need releif cuts in the bottom.
Theres not much info out there about it. Any advice or thoghts would be greatly appreciated
Do I need to route a toung and grove in it. How should I nail it to the sub floor. Does it need releif cuts in the bottom.
Theres not much info out there about it. Any advice or thoghts would be greatly appreciated